Duty Weapon Training Advisory

Discussion in 'Ammo & Reloading' started by greyhawk50, Jul 27, 2013.

  1. greyhawk50

    greyhawk50 Well-Known Member

    1,970
    0
    I borrowed this from another small but informative forum.
    I had never considered this as a potential problem. Good food for thought.

    Quote;
    > THE FOLLOWING TRAINING ADVISORY WAS FORWARDED FROM GWINETT COUNTY
    POLICE DEPARTMENT – LAWRENCEVILLE, GA
    >
    > In September of this year a GCPD officer was involved in a situation
    which quickly became a use of deadly force incident. When the officer
    made the decision to use deadly force, the chambered round in his duty
    pistol did not fire. Fortunately, the officer used good tactics,
    remembered his training and cleared the malfunction, successfully
    ending the encounter.
    >
    > The misfired round, which had a full firing pin strike, was collected
    and was later sent to the manufacturer for analysis. Their analysis
    showed the following: “…the cause of the misfire was determined to
    be from the primer mix being knocked out of the primer when the round
    was cycled through the firearm multiple times”. We also sent an
    additional 2,000 rounds of the Winchester 9mm duty ammunition to the
    manufacturer. All 2,000 rounds were successfully fired.
    >
    > In discussions with the officer, we discovered that since he has small
    children at home, he unloads his duty weapon daily. His routine is to
    eject the chambered round to store the weapon. Prior to returning to
    duty he chambers the top round in his primary magazine, then takes the
    previously ejected round and puts in back in the magazine. Those two
    rounds were repeatedly cycled and had been since duty ammunition was
    issued in February or March of 2011, resulting in as many as 100
    chambering and extracting cycles. This caused an internal failure of
    the primer, not discernible by external inspection.
    >
    > This advisory is to inform all sworn personnel that repeated cycling of
    duty rounds is to be avoided. As a reminder, when loading the weapon,
    load from the magazine and do not drop the round directly into the
    chamber. If an officer’s only method of safe home storage is to
    unload the weapon, the Firearms Training Unit suggests that you unload
    an entire magazine and rotate those rounds. In addition, you should
    also rotate through all 3 duty magazines, so that all 52 duty rounds
    are cycled, not just a few rounds. A more practical method of home
    storage is probably to use a trigger lock or a locked storage box.
    >
    > FURTHER GUIDANCE:
    >
    > The primer compound separation is a risk of repeatedly chambering the
    same round. The more common issue is bullet setback, which increases
    the chamber pressures often resulting in more negative effects.
    >
    > RECOMMENDATION:
    >
    > In addition to following the guidance provided above of constantly
    rotating duty ammunition that is removed during the unloading/reloading
    of the weapon, training ammunition utilized during firearm sustainment
    and weapon manipulation drills, should also be discarded if it has been
    inserted into the chamber more than twice. This practice lessens the
    likelihood of a failure to fire or more catastrophic results.
     
  2. SWO1

    SWO1 Well-Known Member Lifetime Supporting

    2,866
    41
    Good article......Not only for SD ammo but also hunting rounds.
     

  3. squirrelhunter

    squirrelhunter Well-Known Member Lifetime Supporting

    3,359
    30
  4. havasu

    havasu Well-Known Member

    2,185
    20
    Not pointing blame, but his department needs to learn how to use duty ammo for practice, then refilling with fresh ammo on a monthly basis. Yep, it might cost a few bucks more, but how much is a life worth?
     
  5. SHOOTER13

    SHOOTER13 RETIRED MODERATOR Lifetime Supporting

    5,724
    86
    Good info...and food for thought

    Thanks for sharing it Grey !!