Marlin Forums banner
1 - 6 of 6 Posts

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #1 ·
Me and my wife where gone most of the day, Went to Lowes and stayed in there for about an hour while my wife picked out the kitchen faucet she wants me to install .I told her Im not starting it until Monday when the hardware stores are all open they close tomorrow you know Murphy's Law.

My dies where in the mail box when I got home Good old Lee Precision sent me a brand new one. I'm setting up the press tonight and give it another try, What's everybody's experience on this should? I wait till I get a tumbler?
 

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #3 ·

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #5 ·
What is involved the best way to adjust the die, just seat it down till it touches the ram right?
 

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #6 ·
Resized/deprimed 3 cases lubed out side and ran a small amount on the in side with a q tip. The press ran smooth as butter, its late more tomorrow
 

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #8 ·
The directions that came with my die said all that but didn't mention any thing about lower the ram and screw the die in 1/4 to 1/3 turn more. I wonder why is it because of it being a straight waal case.
 

·
Banned
Joined
·
7,853 Posts
Discussion Starter · #10 ·
Your right SW I will call Lee customer service tomorrow.
 
1 - 6 of 6 Posts
Top