Marlin Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
2,858 Posts
Me and my wife where gone most of the day, Went to Lowes and stayed in there for about an hour while my wife picked out the kitchen faucet she wants me to install .I told her Im not starting it until Monday when the hardware stores are all open they close tomorrow you know Murphy's Law.

My dies where in the mail box when I got home Good old Lee Precision sent me a brand new one. I'm setting up the press tonight and give it another try, What's everybody's experience on this should? I wait till I get a tumbler?
Greese em up and run em thru ........ :p
 

·
Premium Member
Joined
·
2,858 Posts
What is involved the best way to adjust the die, just seat it down till it touches the ram right?
full length sizer die is adjusted with "the shell holder" mounted. run the ram all the way up and adjust the die to where it just touches the shell holder. Then lower the ram and run the die another 1/4 to 1/3 turn DOWN. This is copied right off the Lee site:


Full Length Sizer
COMPLETE INSTRUCTIONS FOR LEE RIFLE DIE SETS
Screw the full length sizer in until it touches the shell holder.
Then lower the ram and screw the die in 1/4 to 1/3 turn more.
Raise the ram and tighten the lock ring finger tight.
 

·
Premium Member
Joined
·
2,858 Posts
All my rifle die instructions say the same thing for all calibers, .223, 6mm Rem, 7mm Rem, .243, .270, .308, 30-06, and .35 Rem. But all mine are bottle neck dies, dont have any straight wall ones. Maybe another call to a Lee technician is in Order ?? I didnt look at the pistol instructions to see what they said. I set mine a while back and used the lock rings.

And Steel dies may be different ?? all mine are Carbide.
 
1 - 3 of 3 Posts
Top