Marlin Forums banner
1 - 1 of 1 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
I have a NOE 332 grain Hollow point mold. I have started to load them to get 1500fps out of my 1895sbl with 20gns of blue dot. The load shoots well enough ( about 1.5" at 100 yards) but blue dot is hard to get in Australia and I am nearly out. Have any of you tried unique or similar for this velocity with accuracy. Prefer loads that use Adi Powder that is sold in america as shown below
AS50N = International
AP70N = Universal
AR2205 = H4227
AR2207 = H4198
AR2219 = H322
Bench Mark2 = BenchMark

Regards Browndog
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.