Marlin Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
I asked because I read that a dimple was put in the follower to hold the soft point and thus allowing the last shell to load without getting hung up. Just bought a box and am going to run them through the 30-30 and see what happens. Also going to pull out the follower and take a look.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #7 ·
Took out the plastic follower that had a dimple in it and replaced it with a stainless steel follower that is polished with a dimple. Works much better than the plastic follower and my guess is because of the polished smooth service.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top