Marlin Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Anyone try a setup with both on the dovetail 3/8" mount? Looks like the see-thru scope rings might work so you can use iron or scope.

How did the cheek weld feel? Did it seem a little high?
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
I used a cheap Barska with 3/8 dovetail that worked, but the quality of the scope wasn't there which is a reason not buy a cheap piece of glass. A decent scope might work better. The tech sights were much better, but the issue I had is that you need to check the front sight often especially if you're in the field with it (not bench resting) as the tech sight for the marlin can pop out. I never had this issue with the tech sight on other rifles.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top