Marlin Forums banner
1 - 6 of 6 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
Well i bought a leather sling on Craigslist with hardware for $8...after watching vids on YouTube, I came to the conclusion that the they all seem to over complicate the process. I completely understand the reasons to go that extra step for a flawless and professional looking install, but I really didn't see the need for it... So here I go... I found a drill bit that was just the right diameter (no wider than the core of the thread), taped off the length on the bit, then drilled my penciled marks measured and centered approximately 1.5" from each end... Then screwed in the hardware and that was it... I was going to get washers, but then I felt like doing it and just went for it..... Btw, all completed sitting on the floor against the foot of my bed, which my wife wasn't thrilled about.. Lol.... Check it out


1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.