Raven .25 acp problems

Discussion in 'Gunsmithing' started by murph41, Oct 31, 2014.

  1. murph41

    murph41 Active Member

    I recently received my late grandpa's old raven p25 .25 acp. I had to replace the firing pin so I ordered a new one off of numrich.com. when I got the new pin in the mail I got it switched out and ready to use. Dad test fired it the day I got the new pin. The pistol shot like it was supposed to but it didn't eject properly and the shell casing got bent up.

    The new firing pin sticks out farther than the ejector. Does this have anything to do with what happened during testing? [​IMG]

    What can I do to fix it?
  2. oldbrass

    oldbrass Well-Known Member

    No experience with a .25, I did however have simalar problems with my Bersa .380..Was just a bad magazine

  3. greyhawk50

    greyhawk50 Well-Known Member

    I'm not a gunsmith but, just thinking.
    The firing pin shouldn't stick out at all unless the hammer is pushing (driving) it forward.
    Kind of hard to evaluate without having the gun in hand.