Marlin Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
12 Posts
Discussion Starter · #1 · (Edited)
When did Marlin start offering

336 rifles factory drilled & tapped for scope mounts?

I have seen pics of older rifles without holes in the top of the receiver. Just wondered when they first appeared from the factory WITH mounting holes.

Thanks for any info

(edited to correct stupid typo in subject line)
 

· Registered
Joined
·
12 Posts
Discussion Starter · #4 · (Edited)
Thanks for those comments. The dates you mention are consistent with info I found this afternoon here:
https://www.gun-data.com/marlin336chro2.html

I was hoping to get independent confirmation of this, it is hard to know which sources simply support each other rather than being truly independent corroboration. There are some inconsistencies on this page and several typos. Don't know how reliable it is.

Thanks again.

Update 3/10
Just found an online auction photo of a 1954 RC with tapped holes for scope mount. It has a deluxe stock.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top